Volkswagen Golf Variant 2007 Service Manual page 195

1.4.2 Installing
– Clean seat for seal in gearbox.
– Pull in seal and sleeve together.
A - Screw spindle of assembly tool -3066- into threaded piece of
differential.
B - Nut M12
– Pull in seal with sleeve to stop using thrust piece -T10148- by
turning nut -B-.
– Half-fill space between sealing lip and dust lip with sealing
grease -G 052 128 A1- .
– Insert flange shaft.
– Secure flange shaft with countersunk bolt.
– If turbocharger oil return line was unbolted from engine, bolt it
on again now -arrow- ⇒ Rep. Gr. 21 ; Charge air system for
turbocharger; Removing and installing turbocharger with an‐
cillaries .
– Bolt drive shaft -1- to flange shaft ⇒ Running gear, axles,
steering; Rep. Gr. 40 ; Repairing drive shaft; Removing and
installing drive shafts .
– Install drive shaft heat shield, if present, on engine ⇒ Running
gear, axles, steering; Rep. Gr. 40 ; Repairing drive shafts .
– Check gear oil ⇒ page 99
– Install noise insulation ⇒ General body repairs, exterior; Rep.
Gr. 50 ; Noise insulation .
1.4.3 Torque setting
Flange shaft to gearbox (countersunk bolt)
⇒ Item 12 (page 195)
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
.
6-speed manual gearbox 02S - Edition 07.2009
1. Renewing flange shaft oil seals with gearbox installed
191