Pressing tapered roller bearing outer race into clutch housing
No shim is installed in the clutch housing end.
Pulling off tapered roller bearing inner races
– Before fitting extractor, position thrust plate -40 - 105- on dif‐
ferential cage.
Note
Both tapered roller bearing inner races are pulled off the differ‐
ential cage in the same way.
Pressing on tapered roller bearing inner race
Note
The inner races of tapered roller bearings for gearbox housing
and clutch housing are pressed on with the same press tools.
Pulling outer race for tapered roller bearing out of gearbox hous‐
ing
A - Counter support , e.g. -Kukko 22/2-
B - Internal puller, 46 ... 58 mm , e.g. -Kukko 21/7-
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
197
3. Differential