Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
– Check that gate and selector cables -B- are inserted, free of
tension, into locking devices -A-.
– Now turn locking mechanisms on gear selector cable and gate
selector cable end pieces clockwise to stop
-direction of arrow 1-.
The spring presses the locking mechanism into original position
-direction of arrow 2-.
– Now turn angled rod -A- back to original position
-direction of arrow-.
Note
The angled rod -A- must be pressed out of selector housing to
stop and point to rear.
– Pull locking pin out of holes -A- and -B-.
– If noise insulation was present, install it.
– Install gaiter with selector knob and frame
– Check that selector shaft moves freely.
– If removed, reinstall complete air filter housing ⇒ Rep. Gr.
23 ; Repairing diesel direct injection system or ⇒ Rep. Gr.
24 ; Repairing injection system
2.11.1
Functional check
•
With gearbox in neutral, gear lever must rest in gate for 3rd
and 4th gear.
– Operate clutch.
– Select all gears several times. Pay particular attention to op‐
eration of reverse gear lock.
82
Rep. Gr.34 - Controls, housing
⇒ page 61
.