Distinguishing Seals For Right Flange Shaft - Volkswagen Golf Variant 2007 Service Manual

– Raise drive shaft as high as possible and secure. Take care
not to damage paint on drive shaft in the process.
– Place drip tray under gearbox.
– Remove flange shaft securing bolt by screwing two bolts into
flange and counterholding flange shaft with a lever.
– Pull out flange shaft with compression spring.
– Pull out flange shaft oil seal using multipurpose tool -VW 771-
and puller hooks -VW 771/37- .
1.1.2 Installing
– Drive in new seal to stop, being careful not to cant seal.
– Half-fill space between sealing lip and dust lip with sealing
grease -G 052 128 A1- .
– Insert flange shaft.
– Secure flange shaft with countersunk bolt.
– Attach drive shaft to gearbox ⇒ Running gear, axles, steering;
Rep. Gr. 40 ; Repairing drive shaft; Removing and installing
drive shafts .
– Check gear oil ⇒ page 99
– Install lower part of front left wheel housing liner ⇒ General
body repairs, exterior; Rep. Gr. 66 ; Wheel housing liner .
– Install noise insulation ⇒ General body repairs, exterior; Rep.
Gr. 50 ; Noise insulation .
– Install wheel ⇒ Running gear, axles, steering; Rep. Gr. 44 ;
Torque settings for mounting wheels .
1.1.3 Torque setting
Flange shaft to gearbox (countersunk bolt)
⇒ Item 12 (page 195)
1.2 Distinguishing seals for right flange
shaft
The seal -1- for the right flange shaft is located in a sleeve -2-.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
.
6-speed manual gearbox 02S - Edition 07.2009
1. Renewing flange shaft oil seals with gearbox installed
185