Selector Lever Cable, Removing And Installing - Volkswagen Golf 2015 Repair Manual

– The cable is correctly locked when the grooves on the locking
mechanism are at a right angle to the cable.
– Install new clip -arrow- and replace the plugs.
– Install the heat shield under the selector mechanism. Refer to
⇒ Body Exterior; Rep. Gr. 66 ; Molding/Trim/Extensions/Trim
Panels; Floor Heat Shield, Removing and Installing .
– Install the bracket -2- if equipped. Refer to ⇒ Body Interior;
Rep. Gr. 68 ; Center Console; Center Console, Removing and
Installing .
– Install the air guide channel from the center console. Refer to
⇒ Heating, Ventilation and Air Conditioning; Rep. Gr. 87 ; Air
Routing; Overview - Air Routing and Air Distribution in Pas‐
senger Compartment .
– Install the center console. Refer to ⇒ Body Interior; Rep. Gr.
68 ; Center Console; Center Console, Removing and Instal‐
ling .
– Install the selector lever handle. Refer to
⇒ 2.6 Selector Lever Handle, Removing and Installing , page
33 .
– Selector lever cable, adjusting. Refer to
⇒ 2.4 Selector Lever Cable, Checking and Adjusting ,
page 30 .
– Check the selector mechanism. Refer to
⇒ 2.8 Gearshift Mechanism, Checking , page 36
Tightening Specifications
♦ Refer to ⇒ 2.1 Overview - Selector Mechanism , page 19
2.3 Selector Lever Cable, Removing and In‐
stalling
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Golf 2015 ➤ , Golf Variant 2015 ➤
Automatic Transmission - Edition 11.2014
27
2. Selector Mechanism