Volkswagen Golf Variant 2007 Service Manual page 68

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
25 - Securing clip
❑ Always renew
26 - Hexagon nut
❑ M8: 25 Nm
❑ M6: 8 Nm
❑ Qty. 4
27 - Bearing bush
❑ Fits in one position only
28 - Securing clip
❑ Always renew
Removing and installing gate and gear selector cables
– Remove securing clip from gear selector cable -A- and gate
selector cable -B-.
To do this, raise tab using screwdriver -arrow 1- and press off
securing clip -arrow 2-.
– Remove gear selector cable -A- from gear lever retainer.
– Remove gate selector cable -B- from retainer of gate selector
lever.
Removing and installing securing clip
– To remove or install securing clip -arrow A-, press spacer bush
-arrow B- to stop in direction of arrow -arrow C- using screw‐
driver and pull off securing clip.
Note
Do not cant spacer bush when pushing down.
♦
Slot in gear lever for securing clip must be visible.
♦
Carefully release tension from spring.
♦
Installing compression spring
– Insert compression spring so that extension -A- lies on top of
pin -arrow-.
– Then pull extension -B- down so that it sits below pin -arrow-.
64
Rep. Gr.34 - Controls, housing