Volkswagen Golf Variant 2007 Service Manual page 128

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
– Insert input shaft -1- and output shaft -2- together.
– Tighten nuts for output shaft bearing support to specified tor‐
que ⇒ Item 11 (page 108)
– Set reverse gear wheel -3- on needle bearing in clutch hous‐
ing.
The shoulder -arrow- faces away from the clutch housing.
– Ensure that reverse shaft -4- is complete
yet fit reverse shaft support to reverse shaft.
– Fit reverse shaft into clutch housing.
– Clean locking fluid from all threaded holes in reverse shaft
support; a thread chaser may be used.
– Place reverse shaft support on reverse shaft.
– Attach reverse gear selector fork -1- with support for reverse
gear selector fork -2-, spring -3- and sliding piece -4-.
Installation position, reverse gear
– Bolt on reverse gear selector mechanism -A-, tightening to
specified torque ⇒ Item 8 (page 108)
– Install selector forks -B- together with selector plates.
Reverse gear support pin -C- is located in front of selector plates.
124
Rep. Gr.34 - Controls, housing
.
⇒ page 181
.
; do not