Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
– Slacken ends -A- and -B- by turning both round to right.
•
Ends -A- and -B- must point in opposite directions.
– Fit gear lever guide in selector housing.
•
Pin -arrow 1- is still located in notch in selector housing.
– Turn gear lever guide in -direction of arrow 2- until ball stud
-A- is located in notch in selector housing.
– Place selector housing with gear lever guide into larger recess
-arrow- in thrust piece -T10083- .
Note
To ensure that the selector housing with gear lever guide can be
inserted in the thrust piece , first remove gear lever, if necessary.
•
The gear lever guide must project from the selector housing
up to the stop.
Note
For clarity of illustration, only part of the gate selector lever is
shown.
– Insert end -A- of compression spring into guide from above.
– Pull end -B- of compression spring downwards and insert it
next to guide (in direction of ball joint).
•
Please pay attention to guides (⇒ figure above) during the fur‐
ther procedure.
•
They must not be broken off.
– Carefully remove selector housing with gear lever guide from
thrust piece -T10083- .
68
Rep. Gr.34 - Controls, housing