Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
Installing springs with bent ends -A-
The modified springs are installed on both sides.
– Spring are installed only in conjunction with locking pieces
which are hollow on the inner side.
– Insert locking pieces.
Installation position of springs
– Install springs offset 120°.
– Angled end -A- of spring must locate in hollow locking piece.
It must be located under shoulder -B- of locking piece.
Bent ends always face away from synchro-hub
-direction of arrow-.
1.2
Adjusting input shaft
(Determining input shaft shim)
158
Rep. Gr.35 - Gears, shafts