Aeris Elite T3 Operating Manual page 146

146
Elite T3 Battery Installation (continued) -
 Careful l y pl a ce the cl e ar Battery Hatch (with O- r ing) into
position on the rim of the Battery Compartment, then press it
evenl y and compl e tel y down into pl a ce with your same
thumb.
 Maintain the Battery Hatch securel y in pl a ce and, using your
other hand, sl i de the Hatch Ring down off your thumb and
into position around the Battery Compartment. The tabs on
the Ring fit down into the sl o ts l o cated at the 2 and 9 o'cl o ck
positions.
 Using your fingers, turn the Ring counter cl o ckwise 5 de-
grees until the tabs engage, then tighten it 5 more degrees
by turning it counter cl o ckwise with the aide of a smal l bl a de
screwdriver or spanner tool , pressing against the upper/l e ft
arm of the Ring (Fig. 130).
Transmitter Battery Installation
 Lightl y l u bricate the new Battery Cap O- r ing with sil i cone
grease and instal l it onto the Battery Cap. DO NOT rol l
the O- r ing over the Threads, instead stretch it sl i ghtl y to
work it down over the sl o tted end of the Cap into the
Groove at the Base of the Threads (Fig. 131).
NOTE: The Transmitter's O-ring must be a genu-
ine AERIS part that can be purchased from an
Authorized AERIS Dealer.