Aeris Elite T3 Operating Manual page 100

WARNING:
If a High PO
condition occurs
while in Deco
Mode, the
message HIGH >
PO will replace
the DECO
message until
PO < 1.60.
100
NORM HIGH PO
hen partial pressure of oxygen (PO2) becomes equal to, or
greater than, 0.2 ATA l e ss than the PO2 Al a rm Set Point (a SET
A Group setting); the red LED warning l i ght wil l fl a sh, the Au-
dibl e Al a rm wil l sound, and the message HIGH > PO2 wil l scrol l
until the Al a rm is acknowl e dged/sil e nced.
 The graphic PO2 and UP Arrow wil l appear sol i d on the
MAIN Displ a y (Fig. 85) as a warning until PO2 decreases.
 After the Al a rm is sil e nced, the graphic message UP >
HIGH > PO2 wil l scrol l .
If PO2 continues to increase, the val u e displ a yed wil l increase in
increments of .01 ATA to a maximum val u e of 5.00 ATA.
hen PO2 reaches the PO2 Al a rm Set Point, the red LED
warning l i ght wil l fl a sh and the Audibl e Al a rm wil l sound again.
> The graphic PO2 and UP Arrow wil l fl a sh as a warning
until PO2 decreases bel o w the Al a rm Set Point.
> The message UP > HIGH > PO2 wil l continue to scrol l .
> The val u e of PO2 can be viewed by accessing the ALT 2
Displ a y by pressing/rel e asing the A button 2 times.
> The unit wil l revert to the MAIN Displ a y after 3 seconds.