Motorola MVME2400 Series Programmer's Reference Manual page 91

When performing a configuration cycle, the PHB uses the upper 20
address bits as IDSEL lines. During the address phase of a configuration
cycle, only one of the upper address bits will be set. The device that has its
IDSEL connected to the address bit being asserted is selected for a
configuration cycle. The PHB decodes the Device Number to determine
which of the upper address lines to assert. The decoding of the five-bit
Device Number is show as follows:
The Bus Number determines which bus is the target for the configuration
read cycle. The PHB will always host PCI bus #0. Accesses that are to be
performed on the PCI bus connected to the PHB must have zero
programmed into the Bus Number. If the configuration access is targeted
for another PCI bus, then that bus number should be programmed into the
Bus Number field. The PHB will detect a non-zero field and convert the
transaction to a Type 1 Configuration cycle.
Generating PCI Special Cycles
The PHB supports the method stated in PCI Local Bus Specification 2.1
using Configuration Mechanism #1 to generate special cycles. To prime
the PHB for a special cycle, the host processor must write a 32 bit value to
the CONFIG_ADDRESS register. The contents of the write are defined
later in this chapter under the
After the write to CONFIG_ADDRESS has been accomplished, the next
write to the CONFIG_DATA register causes the PHB to generate a special
cycle on the PCI bus. The write data is driven onto AD[31:0] during the
special cycle's data phase.
http://www.motorola.com/computer/literature
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Device Number Address Bit
00000 AD31
00001 - 01010 All Zeros
01011 AD11
01100 AD12
(etc.) (etc.)
11101 AD29
11110 AD30
11111 All Zeros
CONFIG_ADDRESS Register
Functional Description
definition.
2-33
2