Buell Ulysses 2006 Service Manual page 628

HOME
11966
8
7
1. Main harness
2. Battery ground cable
3. Battery positive cable
4. ECM connectors [10] [11] & [164]
24. Pull rear section of main harness up over trunk pan
towards the rear of the vehicle and place connectors in
general location of installation.
25. Install fuse block and relay center on support bracket.
26. See Figure 7-88. Connect:
Ground terminals on right side tail section.
Tail light connectors [93].
Left turn signal connector [19].
Right turn signal connector [18].
BAS (bank angle sensor) connector [134].
ECM connectors [10], [11] and [164].
Rear brake light switch connector [121].
Ground terminals on left side tail section.
License plate lamp connector [45].
Rear auxiliary power outlet [180].
27. Route main harness and rear auxiliary power outlet wir-
ing under seat latch bracket.
28. Tighten fasteners.
29. Install main harness and grommet into battery tray.
30. Install rear wire cover.
7-74 2006 Buell Ulysses: Electrical
2
5
Figure 7-88. Main Harness and Electrical Connectors Under Seat
4
5. Fuse block and relay center
6. BAS (bank angle sensor) connector [134]
7. Rear auxiliary outlet [180]
8. Center tail section
1
6