Buell Ulysses 2006 Service Manual page 624

HOME
11966
8
7
1. Main harness
2. Battery ground cable
3. Battery positive cable
4. ECM connectors [10] [11] and [164]
5. Fuse block and relay center
6. BAS (bank angle sensor) connector [134]
7. Rear auxiliary outlet [180]
8. Center tail section
NOTE
Rear turn signal, tail lamp and license plate lamp connectors
are inside the license plate bracket.
9. See Figure 7-83. Remove the wire cover to access and
disconnect:
Wire harness ground [GRD 2].
Rear brake light switch connector [121].
ECM connectors [10], {11} and [164].
BAS (bank angle sensor) connector [134].
Right rear turn signal connector [18].
Left rear turn signal connector [19].
License plate lamp connector [45].
Tail light connectors [93].
Rear auxiliary power outlet [180].
See Figure 7-83.
[165B], (under main wiring harness)
7-70 2006 Buell Ulysses: Electrical
2
5
Figure 7-83. Main Harness and Electrical Connectors Under Seat
Interactive exhaust connector
4
10. Remove fuse block and relay center from support
bracket.
11. Loosen seat latch bracket fasteners and remove harness
from under the seat latch bracket.
12. Remove main harness and grommet from battery tray.
13. Remove the rear shock absorber assembly and reser-
voir. See 2.23 REAR SHOCK
14. Remove fan. See 4.38 COOLING
1
6
ABSORBER.
FAN.