Buell Ulysses 2006 Service Manual page 453

HOME
Fuel Filter Replacement
1. Remove fuel pump assembly from tank. See REMOVAL
in this section.
2. See Figure 4-89. Disconnect electrical connectors (5, 6).
3. Remove ground fastener (12) from the fuel pump and
fuel filter bracket (9).
4. Remove fuel pressure regulator E-clip (7).
5. Pull regulator housing (3) and fuel pump (8) with bracket
(9).
6. Remove fuel filter (2).
Remove the rubber seals from each end of the original fuel fil-
ter to be used on the new fuel filter.
10935a
1
11
10932a
1. Fitting
2. Fuel filter
3. Pressure regulator housing
4. Low fuel level sensor
5. Fuel pump connectors
6. Low fuel level sensor connector
7. Pressure regulator E-clip (1)
NOTE
2
10
9
12
Figure 4-89. Fuel Pump Assembly (Left and Right Sides)
7. Install rubber seals on new fuel filter and install filter into
pump housing (11).
8. See Figure 4-89. Install regulator housing (3) and fuel
pump (8) assembly.
9. Install E-clip (7) in bottom groove on shaft.
10. Install ground fastener (12) and connect ground wires to
bracket (9) and tighten to 18-22 in-lbs (2.0-2.5 Nm).
11. Connect electrical connectors (5, 6).
Fuel pump connectors are two different sizes to prevent incor-
rect installation.
12. Route overflow hose (10) through guide in bracket (9).
13. Install fuel pump assembly. See INSTALLATION in this
section.
3
7
6
8
8. Fuel pump
9. Bracket, fuel pump and fuel filter
10. Overflow hose
11. Fuel pump housing
12. Ground fastener
2006 Buell Ulysses: Fuel System 4-111
NOTE
4
5