Buell Ulysses 2006 Service Manual page 609

HOME
INSTALLATION
Right Side
1. Attach throttle cables to hand control. See
TLE CONTROL.
2. Install right switch housing.
a. Position housing on right handlebar by engaging
alignment pin on front housing with hole in handle-
bar.
b. Attach switch housing with two mounting fasteners
and tighten to 25-33 in-lbs (3-4 Nm).
3. Attach brake switch connector [121].
4. Attach right handlebar switch connector [22] to wire har-
ness. See HOSE AND WIRE ROUTING
information.
5. Install the windscreen. See
WINDSCREEN.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
6. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
2.24 THROT-
for wire routing
2.44 WINDSHIELD AND To Ign. relay
From Ign. relay
From Ign. relay
To starter relay
Accessory power
To stoplight
Figure 7-63. Right Handlebar Switch Connection
2006 Buell Ulysses: Electrical
Right Handlebar Switch
[22A] [22B]
GY GY/O
4
W/BK
W/BK
3
W/BK
W/BK
2
BK/R
BK/R
1
O O
1
R/Y
R/Y
2
[121A] [121B]
Brake Switch
7-55