Buell Ulysses 2006 Service Manual page 136

HOME
i04279
2
1. Bridge
2. Forcing screw
3. Nut
Figure 2-10. Remove the Bearing
10. See Figure 2-11. Loosen the nut (1), and back off the
bridge (2). Hold the forcing screw (3) while holding the
collet (4) to remove the forcing screw from the collet.
11. Remove the ball bearing (5) and wheel bearing (6) from
the collet (4).
i04282
3
1. Nut
2. Bridge
3. Forcing screw
4. Collet
5. Ball bearing
6. Wheel bearing
Figure 2-11. Removing Bearing from Puller
12. See Figure 2-12. Remove the spacer.
2-12 2006 Buell Ulysses: Chassis
1
3
5
4
6
2
1
i04280
Figure 2-12. Remove the Spacer
13. Repeat Steps 4-12 for the bearing on the other side of
the wheel.
Front Rotor Removal
1. See Figure 2-18. Remove and discard rotor mounting
fasteners (7).
2. Remove and inspect brake rotor (6) for wear and warp-
ing. See 2.12 FRONT BRAKE
3. Remove drive bushings (8) and discard.
4. Remove washers (9) and discard.
5. Remove front brake springs (4) and discard.
CLEANING AND INSPECTION
11 1
WARNING
Never use compressed air to "spin-dry" bearings. Very
high bearing speeds can damage unlubricated bearings.
Spinning bearings with compressed air can also cause a
bearing to fly apart, which could result in death or seri-
ous injury.
1. Inspect all parts for damage or excessive wear.
NOTE
The wheel bearings are designed as sealed bearings which
are not intended to be disassembled, serviced or cleaned
with solvents.
11 1
WARNING
Always replace brake pads in complete sets for correct
and safe brake operation. Improper brake operation
could result in death or serious injury. (00111a)
2. Inspect brake rotor and pads. See
MAINTENANCE.
CALIPER.
WARNING
WARNING
1.6 BRAKE SYSTEM