Buell Ulysses 2006 Service Manual page 200

HOME
INSTALLATION
1. See Figure 2-110. Install headlight support bracket (9).
2. Apply LOCTITE 272 (red) and install fasteners (8) secur-
ing headlight support bracket/turn signal flasher to left
and right front modules (10) and tighten to 48-72 in-lbs
(5.4-8.1 Nm).
3. Install headlight assembly.
a. Install headlight assembly (7) into headlight support
bracket (9).
b. Install both upper headlight fasteners (6) but do not
tighten.
c. Install lower fastener (under the front fender), do not
tighten.
4. Attach headlight connector to headlight support bracket.
5. Connect headlight connector [38] (5).
6. Install horn (1) and tighten fastener (4) to 36-60 in-lbs
(4-6.7 Nm).
7. Connect horn connectors [122] (2).
8. Adjust headlights. See 1.18
11930a
10
6
1. Horn
2. Horn connectors [122]
3. Horn bracket
4. Horn fastener
5. Headlight connector [38]
2-76 2006 Buell Ulysses: Chassis
HEADLIGHTS.
2
1
8
7
Figure 2-110. Headlight and Support Bracket
9. Install flyscreen and windscreen. See
SHIELD AND WINDSCREEN.
11 1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
10. Install battery by threading positive cable (red) into
threaded hole first tightening to 72-96 in-lbs (8-11 Nm).
See 1.4 BATTERY MAINTENANCE.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
11. Install seat. See 2.45 SEAT.
4
3
8
7
6. Screws (2), upper headlight mounting
7. Headlight assembly
8. Screws (2), headlight support bracket
9. Headlight support bracket
10. Left and right front modules
2.44 WIND-
WARNING
WARNING
5
10
9
6