Buell Ulysses 2006 Service Manual page 500

HOME
Table 6-5. Wet Clutch Multiple Disc-maximum Allowable Warpage
ITEM
Friction plate (fiber)
Steel plate
TORQUE VALUES
ITEM
Axle pinch fastener, rear
Axle, rear
Chin fairing fasteners
Clutch inspection cover fas-
teners
Clutch mainshaft nut
Countershaft retaining screw
Crankcase 5/16 in. fasteners
Engine sprocket nut
Idler pulley wheel fastener
Magnetic drain plug
Negative battery cable at bat-
tery terminal
Neutral indicator switch
Primary cover fasteners
Shift lever pinch screw
Shift linkage fasteners
Shift pedal flange head bolt
Shifter bracket fasteners
Transmission sprocket nut
Transmission sprocket screws
6-2 2006 Buell Ulysses: Drive/Transmission
NEW COMPONENTS
N/A
N/A
TORQUE
40-45 ft-lbs 54-61 Nm
Special
procedure
36-48 in-lbs 4-5 Nm
84-108 in-lbs 9.5-12.2 Nm
70-80 ft-lbs 94.9-108.5 Nm
33-37 ft-lbs 44.8-50 Nm
15-19 ft-lbs 20.3-25 Nm
190-210 ft-lbs 257.6-284.7 Nm
20-23 ft-lbs 27.1-31.2 Nm
14-30 ft-lbs 19-40.7 Nm
72-96 in-lbs 8-11 Nm
100-120 in-lbs 11-13.5 Nm
100-120 in-lbs 11.3-13.5 Nm
48-60 in-lbs 5.4-6.8 Nm
36-60 in-lbs 4-6.8 Nm
22-24 ft-lbs 30-32.5 Nm
22-24 ft-lbs 30-32.5 Nm
Special
procedure
90-110 in-lbs 10.2-12.4 Nm
SERVICE WEAR LIMITS
0.0059 in. (0.150 mm)
0.0059 in. (0.150 mm)
NOTES
page 6-54
ANTI-SEIZE, page 6-54
LOCTITE 272 (red), page 6-24
page 6-6
Apply LOCTITE 272 (red) onto threads on end of
mainshaft, left hand threads,page 6-20
LOCTITE 272 (red), page 6-51
Apply several drops of LOCTITE 272 (red) to last few
threads, page 6-48
Apply LOCTITE 272 (red) onto threads of sprocket
shaft, page 6-19
page 6-24
page 6-5
page 6-6
LOCTITE 242 (blue), page 6-48
Follow torque sequence, page 6-5
LOCTITE 272 (red), Page 6-6
LOCTITE 272 (red), page 6-6
LOCTITE 272 (red), page 6-6
LOCTITE 272 (red), page 6-6
LOCTITE 272 (red), left hand threads, special torque
turn method, page 6-53
Replace after 3 removals, page 6-53