Buell Ulysses 2006 Service Manual page 65

HOME
Code 22 Test (Page 2 of 2)
Connect battery voltage to [178B] pin 2 of active
intake solenoid. (Use HD 41404 brown pin and patch
cable). Hold throttle wide open. Observe throttle plate
and connect solenoid pin 1 to ground.
Does solenoid attempt to pull throttle almost closed?
Hold throttle wide open. Energize
active intake solenoid. Does throttle
close to an angle less than 11
degrees?
YES
Replace ECM
Measure resistance from active intake solenoid pin 1
to pin 2 [178B] (use HD 41404 brown pins).
Continuity should be present, approximately less
than 4 ohms, nominal 2.4 ohms.
YES
YES
See CABLE ADJUSTMENT
in this section.
NO
Replace solenoid.
NO
Replace solenoid
NO
2006 Buell Ulysses: Appendix E E-7