Buell Ulysses 2006 Service Manual page 596

HOME
BATTERY CABLE ROUTING
Positive battery cable runs from starter post to positive bat-
tery terminal. Negative battery cable runs from frame to neg-
ative battery terminal. See Figure 7-45.
BATTERY INSTALLATION AND
CONNECTION
1. Place the fully charged battery into the battery box, ter-
minal side up.
CAUTION
Connect the cables to the correct battery terminals. Fail-
ure to do so could result in damage to the motorcycle
electrical system. (00215a)
1 1
WARNING WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
CAUTION
Do not over-tighten bolts on battery terminals. Use rec-
ommended torque values. Over-tightening battery termi-
nal bolts could result in damage to battery terminals.
(00216a)
2. Insert fastener through battery positive cable (red) into
threaded hole of battery positive (+) terminal. Tighten
fastener to 72-96 in-lbs (8-11 Nm).
3. Insert fastener through battery negative cable (black) into
threaded hole of battery negative (-) terminal. Tighten
fastener to 72-96 in-lbs (8-11 Nm).
4. Apply a light coat of petroleum jelly or corrosion retardant
material to both battery terminals.
7-42 2006 Buell Ulysses: Electrical
8907a
Figure 7-45. Negative Battery Cable
5. Install battery strap.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
6. Install seat. See 2.45 SEAT.