Buell Ulysses 2006 Service Manual page 229

HOME
ASSEMBLY
1. Install sidestand leg (1).
a. See Figure 2-139. Lubricate sidestand pivot bolt and
mating portions on sidestand bracket with WHEEL
BEARING GREASE (Part No. 99855-89).
NOTE
The sidestand pivot bolt should be lubricated everytime the
sidestand leg is removed from the bracket and at every 5000
mile (8000 km) sidestand pivot bolt service interval.
b. See Figure 2-140.
threaded area (clevis) of sidestand leg.
NOTE
Applying LOCTITE to threaded area of clevis on sidestand
leg, instead of threads on the pivot bolt, will eliminate build-up
between clevis and sidestand bracket which can interfere with
the applied lubricant.
c. See Figure 2-138. Install sidestand leg (5) and side-
stand pivot bolt (1) tightening to 18-20 ft-lbs (24-
27 Nm).
d. Retract sidestand leg.
e. Install spring extension plate (6) and sidestand
spring (7) using SNAP-ON SPRING TOOL (Part No.
HE-52B).
NOTE
Extension plate should curve away from primary chain adjust-
ment screw to allow for clearance around adjustment screw.
INSTALLATION
1. Install sidestand to frame. Apply LOCTITE 272 (red) to
fasteners and tightening s to 25-27 ft-lbs (34-37 Nm).
2. Install muffler. See Muffler and Straps
SYSTEM.
3. Inspect sidestand.
Apply LOCTITE 272 (red) to
in 2.32 EXHAUST
b1128x3x
Figure 2-139. Lubricating Points (Shaded Areas)
b1127x2x
Figure 2-140. Threaded Area for Loctite Application
2006 Buell Ulysses: Chassis 2-105