Buell Ulysses 2006 Service Manual page 487

HOME
STARTER
REMOVAL
1. Remove seat. See 2.45
1 1
WARNING WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Disconnect battery. See
3. Remove primary cover. See
4. Remove sprocket cover. See
NOTE
A ball hex driver may be required to gain access to the starter
mounting bolts.
5. See Figure 5-8. Remove two starter mounting bolts and
washers (1).
6. See Figure 5-9. Remove fastener with washer (1) (met-
ric).
a. Remove protective boot.
b. Remove positive battery cable ring terminal (2).
c. Detach solenoid wire (3).
7. Remove starter and gasket from the gearcase cover side.
SEAT.
1.4 BATTERY MAINTENANCE.
6.2 PRIMARY COVER.
2.35 SPROCKET COVER.
1. Mounting bolts and washers
2. Starter
Figure 5-8. Starter Mounting
8742
1
1. Fastener with washer (metric)
2. Positive battery cable ring terminal
3. Solenoid wire
Figure 5-9. Starter Wires (Protective Boot Not Shown)
2006 Buell Ulysses: Starter
5.7
b0312x5x
1 2
1
3
2
5-13