Buell Ulysses 2006 Service Manual page 104

HOME
Set Rear Shock Preload
NOTES
See Figure 1-37. Adjust the preload by turning the pre-
load adjuster knob located on the left side of the vehicle
according to Table 1-10.
Rotate adjuster clockwise to increase preload.
Rotate adjuster counter clockwise to decrease preload.
Set Rear Shock Rebound Damping
1. See Figure 1-38. Using a screwdriver, turn the slotted
rebound adjustment dial clockwise until it stops. This is
the maximum rebound damping setting.
2. Then turn the dial counterclockwise the number of turns
recommended in Table 1-10.
11958
Figure 1-37. Rear Shock Preload Adjuster
11121
Figure 1-38. Rear Shock Rebound Adjustment Dial
1-36 2006 Buell Uylsses: Maintenance
Setting Rear Shock Compression
Damping
1. See Figure 1-39. Using a screwdriver, turn the slotted
dial clockwise until it stops. This is the maximum com-
pression damping setting.
2. Turn the dial counterclockwise the number of turns from
maximum specified in Table 1-10.
10658a
Figure 1-39. Rear Shock Compression Adjuster