Frame - Buell Ulysses 2006 Service Manual

HOME

FRAME

REMOVAL
1. Remove fuel from frame. See
4.39 FUEL PUMP.
2. Rotate engine. See 3.3 ENGINE ROTATION FOR SER-
VICE.
3. Remove exhaust header. See
4. Remove tail frame. See
BATTERY PAN.
5. Remove rear shock.
ABSORBER.
6. Remove upper and lower fork clamps. See
CLAMPS, UPPER AND
7. Remove main wire harness. See
NESS.
8. Remove rear isolator fastener. See
MOTORCYCLE FOR ENGINE
9. See Figure 2-90. Lift and remove frame from the motor-
cycle.
INSTALLATION
1. Place frame over the motorcycle.
2. Install rear isolator fastener. See
LATION.
3. Install main wire harness. See
NESS.
4. Install upper and lower fork clamps. See
CLAMPS, UPPER AND
5. Install rear shock. See 2.23 REAR SHOCK
6. Install tail frame. See 2.41 LEFT TAIL SECTION AND
BATTERY PAN.
7. Install exhaust header. See
8. Rotate engine. See 3.3 ENGINE ROTATION FOR SER-
VICE.
DRAINING FUEL TANK
2.32 EXHAUST SYSTEM.
2.41 LEFT TAIL SECTION AND
See 2.23 REAR SHOCK
2.17 FORK
LOWER.
7.24 MAIN WIRE HAR-
3.4 STRIPPING
SERVICE.
3.5 ENGINE INSTAL-
7.24 MAIN WIRE HAR-
2.17 FORK
LOWER.
ABSORBER.
2.32 EXHAUST SYSTEM.
8483
in
Figure 2-90. Lift Frame Off Motorcycle (Typical)
2006 Buell Ulysses: Chassis
2.21
2-63