Buell Ulysses 2006 Service Manual page 272

HOME
30. See Figure 3-50. Install oil cooler oil feed line first at oil
pump and tighten to 22-24 ft-lbs (29.8-32.5 Nm). Lightly
coat the threads of the oil cooler fitting with clean H-D
20W50 engine oil. Wipe off any excess oil. Tighten feed
oil line to 19-21 ft-lbs (25.8-28.5 Nm) at oil cooler making
sure to center the oil line between the oil sending switch
and the return oil line fitting on the crankcase.
NOTE
When installing the oil cooler return oil line it is necessary to
install the end at the crankcase first.
31. Install the oil cooler return oil line at crankcase and
tighten to 15-17 ft-lbs (20.3-23 Nm). Lightly coat the
threads of the oil cooler fitting with clean H-D 20W50
engine oil. Wipe off any excess oil. Tighten return oil line
to 19-21 ft-lbs (25.8-28.5 Nm) at oil cooler.
32. Install oil cooler line clamp. Tighten fastener to 12-36 in-
lbs (1-4 Nm).
b1031x3x
Oil cooler feed line
should be centered
after line is torqued.
Orientation of return line
should be approximately
6 o'clock
Figure 3-50. Oil Cooler Feed and Return Oil Lines Location and Orientation
3-38 2006 Buell Ulysses: Engine
NOTE
See Figure 3-50. The orientation of the oil cooler return oil
line where it enters the crankcase should be at approximately
6 o'clock to allow for proper alignment and clearance of other
components on the vehicle.
1
1. Oil cooler feed oil line front oil pump.
2. Oil cooler return oil line to crankcase
Figure 3-49. Oil Cooler Oil Lines
10501
2