Buell Ulysses 2006 Service Manual page 606

HOME
INSTALLATION
Front
1. See Figure 7-54. Insert bullet connectors and wiring
through hole in front module.
2. Install turn signal using lockwasher and jam nut. Tighten
fastener to 25-28 in-lbs (2.8-3.2 Nm).
b1100x7x
Left Turn
[31A]
Signal
Right Turn
Signal
[31A]
Figure 7-57. Front Turn Signal Connections
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-57.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
5. Install windscreen and windshield. See
SHIELD AND WINDSCREEN.
7-52 2006 Buell Ulysses: Electrical
BE V
1 1
BK
BK
2 2
[31B]
BK BK
2 2
BE BN
1 1
[31B]
2.44 WIND-
Rear
1. See Figure 7-57. Insert bullet connectors through license
plate bracket.
NOTE
Be sure tab on turn signal fits into hole in reflector bracket
and tab on reflector bracket fits into hole in enter tail section.
2. See Figure 7-56. Attach turn signal using lockwasher
and fastener (4).Tighten fastener to 25-28 in-lbs (2.8-3.2
Nm).
Left turn signal
Tail lamp
[18A]
[18A]
Right turn signal
Figure 7-58. Rear Turn Signal Connections
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-58.
4. Install wire cover. See
ASSEMBLY.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
6. Install seat. See 2.45 SEAT.
b1239x1x
[19A] [19B]
V
1
1
[19B]
[19A]
BK
2 2
[93A] [93B]
R/Y
1 1
2 BK
2
3 3
O/W
[18A]
BN
1 1
[18A]
BK
2
2
7.14 LICENSE PLATE LAMP