Stripping Motorcycle For Engine Service - Buell Ulysses 2006 Service Manual

HOME

STRIPPING MOTORCYCLE FOR ENGINE SERVICE

DISASSEMBLY
NOTE
Vehicle should be placed onto the lift with rear tire in the
wheel vise in order to successfully perform this procedure.
1. Disconnect fuel pump and run vehicle until it is out of
fuel. See 4.39 FUEL PUMP.
NOTES
This step is always performed in order to purge fuel lines.
The connection for fuel pump is just above the pump
located at the rear of the fuel tank on the left side of the
vehicle.
2. Drain oil tank.
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
10646a
1. Fuel line connection
2. Connection for throttle position sensor [88]
3. Connections for fuel injectors [84 & 85]
WARNING
Figure 3-14. Fuel Line and DDFI Electrical Connections (Typical)
3. Remove seat and disconnect battery.
4. Remove intake cover and airbox assembly. See
INTAKE COVER.
5. Remove throttle body velocity stack.
NOTES
The XB12X model has a clamp ring securing the velocity
stack to the throttle body.
Install shop towel in entrance to throttle body to prevent
objects from falling into the induction module.
6. See Figure 3-14. Disconnect fuel line.
7. Disconnect throttle position sensor (2) [88].
8. Disconnect fuel injector leads (3) [84 & 85].
2
2006 Buell Ulysses: Engine
3.4
2.39
3
1
3-19