Buell Ulysses 2006 Service Manual page 610

HOME
Left Side
1. Install left switch housing.
a. Position housing on left handlebar by engaging
alignment pin on front housing with hole in handle-
bar.
b. Attach switch housing with three mounting fasteners
and tighten to 25-33 in-lbs (3-4 Nm).
2. Connect clutch switch [95].
3. Attach right handlebar switch connector [24] to wire har-
ness. See HOSE AND WIRE ROUTING
information.
4. Install the windscreen. See
WINDSCREEN.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
5. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Check headlight LOW and HIGH beam settings.
c. Set headlight to LOW beam. Press passing lamp
switch. Headlight should flash HIGH beam for as
long as the switch is pressed.
d. Check left and right turn signals.
e. Activate horn by pressing horn switch.
7-56 2006 Buell Ulysses: Electrical
for wire routing
2.44 WINDSHIELD AND
b1103a7x
To headlight
Light power
High beam
From flasher
Left turn
Right turn
Horn power
To interlock circuit
Figure 7-64. Left Handlebar Switch Connection
Left Handlebar Switch
[24A] [24B]
Y
Y
1
BE BE
2
W W
3
Horn
Y/BK Y/BK
4
BE/W V/BN
5
V
V 6
BN BN
7
O O
8
O
TN/LTGN
1
To ground
BK
2
[95B] [95A]
Clutch Switch