Buell Ulysses 2006 Service Manual page 144

HOME
NOTE
Never tighten rear axle with swingarm brace removed.
7. See Figure 2-26. Tighten rear axle (1) to 23-27 ft-lbs
(31.2-36.6 Nm), back off two full turns and then retighten
to 48-52 ft-lbs (65.1-70.5 Nm).
8. Tighten pinch fastener (2) on right side of swingarm to
40-45 ft-lbs (54-61 Nm).
9. See Figure 2-27. Install caliper carrier and tighten fas-
tener to 24-26 ft-lbs (32-35 Nm).
NOTE
The brake pads may become cocked and will not allow the
rotor to slide into the caliper. Press on the brake pad from the
outside of the caliper to straighten out the pad.
11 1
WARNING
After repairing the brake system, test brakes at low
speed. If brakes are not operating properly, testing at
high speeds can cause loss of control, which could
result in death or serious injury. (00289a)
2-20 2006 Buell Ulysses: Chassis
WARNING
11810
1
1. Axle
2. Pinch bolt
Figure 2-26. Rear Wheel Mounting, Right Side
11169
Figure 2-27. Rear Brake Caliper Carrier Fasteners
2