Buell Ulysses 2006 Service Manual page 454

2006 buell ulysses
Table of Contents

Advertisement

HOME
Fuel Screen Replacement
1.
Remove fuel pump assembly from tank. See REMOVAL
in this section.
2.
See
Figure 4-89.
Disconnect electrical connectors (5, 6).
3.
Remove ground fastener (12) from the fuel pump and
fuel filter bracket (9).
4.
Remove fuel pressure regulator E-clip (7).
5.
Pull regulator housing (3) and fuel pump (8) with bracket
(9) as an assembly.
6.
See
Figure 4-90.
Pry fuel screen (1) from fuel pump (2).
7.
Install new fuel screen on fuel pump.
8.
Install regulator housing assembly (4, 5) and fuel pump
(2).
9.
Install E-clip (8) in bottom groove on shaft.
10. See
Figure 4-89.
Install ground fastener (12) and con-
nect ground wires to bracket (9) and tighten to 18-22 in-
lbs (2.0-2.5 Nm).
11. Connect fuel pump connectors (5, 6).
b1173x4x
1.
Fuel screen
2.
Fuel pump
3.
Low fuel level sensor
4.
Fuel pressure regulator housing
5.
Fuel pressure regulator
4-112 2006 Buell Ulysses: Fuel System
10
9
8
Figure 4-90. Fuel Pump Assembly
Fuel pump connectors are two different sizes to prevent incor-
rect installation.
12. Route overflow hose (10) through guide in bracket (9).
13. Install fuel pump assembly. See INSTALLATION in this
section.
Table 4-38. Fuel Pump
Specifications
SPECIFICATION
Pressure Setting
Operating Voltage
Fuel Delivery
Current Draw
7
2
1
6.
Plastic retaining ring, pressure regulator
7.
Fuel filter
8.
E-clip
9.
Connectors, fuel pump
10. Fuel pump wiring harness
NOTE
DATA
49 PSI
13.2 volts
60 LPH @ 45 PSI [310 kPa]
6.0 amps
6
4
5
3

Advertisement

Table of Contents
loading

Table of Contents