Table of Contents
Advertisement
HOME
Test 4.9
YES
Set engine stop switch to OFF.
Disconnect ECM connector [10] and
connect Breakout Box.
Turn ignition key switch ON. Jumper
Breakout Box (BK) Pin 4 to ground.
1
Check engine lamp should be ON. Is it?
YES
Replace ECM. See
2
4.30 ELECTRONIC
CONTROL
MODULE.
7130
3
short to voltage on
BK/Y wire between
connector [39] and
Turn ignition key switch ON. Set engine stop
switch to RUN. Does the engine start?
NO
Connect jumper wire from pin 7 at connector
[39] to ground. Check, is engine lamp on?
YES
Repair open or
Disassemble instrument
module. Inspect check
engine lamp bulb.
connector [10B].
7151
Replace bulb.
Did check engine lamp and no start
conditions occur simultaneously?
YES
No ECM power.
Refer to
4.12 NO
ECM
POWER.
NO
Bulb failed?
7145
YES
Replace Instrument module. See
7.19 INSTRUMENT MODULE
2006 Buell Ulysses: Fuel System
NO
NO
Refer to
4.11 ENGINE
CRANKS BUT WILL
NOT START
for no start
condition and then return
to
4.9 CHECK ENGINE
LAMP NOT ILLUMI-
NATED AT KEY ON
to
resolve no engine
check lamp.
NO
4-19
Advertisement
Chapters
Table of Contents
