Buell Ulysses 2006 Service Manual page 231

HOME
INSTALLATION
1. Install the LH grab handle unto the front fastener and
install the rear fastener. Do not tighten.
2. Slide the spring into the LH grab handle.
3. Press the spring with the shaft of the triple tail rack and
hold the rack in place capturing the spring.
4. Holding the rack, fit the RH grab handle unto the front
fastener and install the rear fastener. Do not tighten.
5. See Figure 2-142. Apply LOCTITE 272 (red) to LH and
RH grab handle fasteners.
b1188x2x
5
2
1
1. Front fastener, grab handle
2. RH grab handle
3. Rear fastener with washer, grab handle
4. Bearing (2)
5. Tail rack
6. Spring
7. Pin
4
3
Figure 2-142. Triple Tail, Passenger Backrest and Luggage Rack
a. Tighten rear fasteners (3, 11) to 23-25 ft-lbs (31-34
Nm). Tighten
b. Tighten front fasteners (1, 12) to 96-120 in-lbs (11-
13.5 Nm).
6. Verify that the rack operates properly.
7. Install the plastic collar and tighten the fastener to 36-48
in-lbs (4.0-5.4 Nm).
8. Install the plastic wire cover under the license plate lamp.
Tighten the screws to 36-48 in-lbs (4.0-5.4 Nm) and
tighten the nuts to 12-36 in-lbs (1.4-4.0 Nm).
10
9
8
7
11
6
4
14
8. Detent, tail rack
9. Screw, collar
10. Collar, tail rack
11. Rear fastener with washer, grab handle
12. Front fastener, grab handle
13. LH grab handle
14. Tail loop
2006 Buell Ulysses: Chassis 2-107
13
12