Stripping Motorcycle For Engine Service - Buell XB9R 2003 Service Manual

Hide thumbs Also See for XB9R 2003:

Table of Contents

STRIPPING MOTORCYCLE FOR ENGINE SERVICE

Vehicle should be placed onto the lift with rear tire in the

wheel vise in order to successfully perform this procedure.

Disconnect fuel pump and run vehicle until it is out of

fuel. See 4.40 FUEL PUMP.

This step is always performed in order to purge fuel lines.

The connection for fuel pump is just above the pump

located at the rear of the fuel tank on the left side of the

Drain oil tank.

Fuel line connection

Connection for throttle position sensor [88]

Figure 3-16. Fuel Line and DDFI Electrical Connections

To protect against shock and accidental start-up of vehi-

cle, disconnect the negative battery cable before pro-

ceeding. Inadequate safety precautions could result in

death or serious injury.

Remove seat and disconnect battery.

Remove intake cover and airbox assembly.

Remove throttle body velocity stack.

Install shop towel in entrance to throttle body to prevent

objects from falling into the induction module.

Figure 3-16.

Disconnect fuel line.

Disconnect throttle position sensor [88].

Disconnect fuel injector leads [84 & 85].

Connections for fuel injectors [84 & 85]

2003 Buell XB9R: Engine