Mazda RX-8 Workshop Manual page 3944

< Previous Next >
2011 - RX-8 - Body and Accessories
REAR AUTO LEVELING SENSOR INSPECTION
1. Connect three 1.5 V dry cell batteries in a series.
2. Connect the positive pole of the battery to auto leveling sensor terminal A, and the negative
pole to terminal D, then apply voltage of 4.5 V between terminals A and D.
3. Connect the tester as shown in the figure.
4. Verify that the voltage fluctuates linearly in the 0.5 to 4.1 V range while the links are moved
up and down slowly.
If not indicated in the graph, replace the rear auto leveling sensor.