Mazda RX-8 Workshop Manual page 3907

9. Start the engine so that the battery remains charged.
10. Turn the front fog lights on.
11. Place a partition screen in front of the fog light not being adjusted to block its light beam.
12. Verify that the brightness border line of the front fog light is at the position indicated on the adjustment screen.
If the brightness border line is not at the position indicated on the adjustment screen, perform the following
adjustment.
< Previous Next >
Turn up the mudguard.
Loosen the adjusting bolt and the screw.
Move the front fog light in the direction of the arrow shown in the figure to adjust the
brightness border line to the position indicated on the adjustment screen.
Install the adjusting bolt and tighten the screw.
© 2010 Mazda North American Operations, U.S.A.
Back to Top