Mazda RX-8 Workshop Manual page 3983

< Previous Next >
2011 - RX-8 - Body and Accessories
WINDSHIELD WIPER MOTOR INSPECTION
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to windshield wiper motor terminal A or B, and ground to
terminal D, then verify that the windshield wipers operate as shown in the table.
If the windshield wipers do not operate as indicated in the table, replace the
windshield wiper motor.
3. Operate the wipers, disconnect battery positive voltage from terminal B, and then verify that
the wipers stop.
4. Connect windshield wiper motor terminals E and A, and apply battery positive voltage to
terminal C.
5. Operate the wipers at low speed, and verify that they stop in the park position.
If there is any malfunction, replace the windshield wiper motor.
< Previous Next >
Back to Top