Mazda RX-8 Workshop Manual page 3974

< Previous Next >
2011 - RX-8 - Body and Accessories
RAIN SENSOR REMOVAL/INSTALLATION
CAUTION:
The reflection rate at the moment the ignition switch is first turned on after replacing the rain sensor with a new one is
stored as the condition indicating zero precipitation on the windshield. Therefore, before turning on the ignition switch,
remove water and dirt from the windshield.
In addition, rain sensor initialization is performed for the following cases: (See
The windshield is replaced and the rain sensor is reused.
The auto wiper system operates incorrectly.
1. Disconnect the negative battery cable.
2. Insert the fastener remover wrapped with protective tape into the notch of the rain sensor cover. Then disconnect the tab A
by turning the fastener remover in the direction of the arrow.
3. Remove the rain sensor cover in the direction of the arrow A.
4. Disconnect the rain sensor connector.
RAIN SENSOR INITIALIZATION SETTING.)