Mazda RX-8 Workshop Manual page 4074

< Previous Next >
2011 - RX-8 - Body and Accessories
SIRIUS SATELLITE RADIO ANTENNA FEEDER INSTALLATION
CAUTION:
If the antenna feeder is installed with tension on the cable and wiring harness it could
result in loosening of the connection areas and poor contact. When installing and
connecting the antenna feeder, always make sure there is slack on the cable and wiring
harness.
NOTE:
The antenna feeder is integrated with the vehicle wiring harness.
When installing a new antenna feeder, secure it to the vehicle wiring harness along the
installation route of the old antenna feeder.
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Sunroof seaming welt (with sunroof)
b. Roof side trim (See
c. Inner scuff plate (See
d. Front side trim (See
e. A-pillar trim (See
f. Rear seat (See
g. Tire house trim (See
h. Rear pillar trim (See
i. Map light (See
j. Interior light (See
k. Sunvisor (See
l. Assist handle (See
m. Headliner (See
n. Trunk end trim (See
ROOF SIDE TRIM
INNER SCUFF PLATE
FRONT SIDE TRIM
A-PILLAR TRIM REMOVAL/INSTALLATION.)
REAR SEAT REMOVAL/INSTALLATION.)
TIRE HOUSE TRIM
REAR PILLAR TRIM
MAP LIGHT REMOVAL/INSTALLATION.)
INTERIOR LIGHT
SUNVISOR REMOVAL/INSTALLATION.)
ASSIST HANDLE
HEADLINER REMOVAL/INSTALLATION.)
TRUNK END TRIM
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)