Mazda RX-8 Workshop Manual page 1487

Rear Drive Shaft Clip Installation Note
1. Point the opening of the new drive shaft clip upward, install it to the clip groove at the end of the rear drive shaft with the
installation width within the specification.
Standard
32 mm {1.3 in}
2. After installing the clip, measure the outer diameter. If it exceeds the specification, reinstall the new clip.
Rear Drive Shaft Installation Note
1. Apply differential oil to the differential oil seal lip.
CAUTION:
The sharp edges of the rear drive shaft can slice or puncture the oil seal. Be careful not to damage the oil seal
when installing the rear drive shaft from the rear differential.
2. Apply grease (L2Y1 33247) to the wheel bearing inner race and rear drive shaft contact surface (Area A in figure).
3. Insert the rear drive shaft into the rear differential with the clip opening facing upward.
4. Insert the rear drive shaft to the wheel hub.
5. After installation, verify that the rear drive shaft is securely held by the clip by pulling the outer ring on the differential side
towards the axle.
Locknut Installation Note
1. Tighten a new locknut.
2. Crimp the locknut, using a chisel and hammer.