terminal D and body ground.
Is there continuity?
INSPECT COMBINED SENSOR
4
Inspect the combined sensor.
(See
COMBINED SENSOR
Is the combined sensor normal?
VERIFY DTC TROUBLESHOOTING COMPLETED.
5
Clear the DTC from the memory.
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY
CONTROL
Start the engine and drive the vehicle at 10 km/h
{6.0 mph} or more.
Are the same DTCs present?
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY
CONTROL
VERIFY AFTER REPAIR PROCEDURE.
6
Are any other DTCs present?
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY
CONTROL
< Previous Next >
INSPECTION.)
(DSC)].)
(DSC)].)
(DSC)].)
© 2010 Mazda North American Operations, U.S.A.
Step 5.
YesGo to the next step.
No Replace the combined sensor, then go to the next
step.
(See
COMBINED SENSOR
REMOVAL/INSTALLATION.)
YesReplace the DSC HU/CM, then go to the next step.
(See
DSC HU/CM
REMOVAL/INSTALLATION.)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY
CONTROL
(DSC)].)
No DTC troubleshooting completed.
Back to Top