Mazda RX-8 Workshop Manual page 1539

< Previous Next >
2011 - RX-8 - DriveLine/Axle
PROPELLER SHAFT REMOVAL/INSTALLATION
For Carbon-Fiber Propeller Shaft
CAUTION:
The carbon-fiber-reinforced propeller shaft could be chipped or cracked if dropped. To
prevent any damage, handle the shaft with careful attention when removing/installing.
Replace the propeller shaft if it is dropped.
1. Remove the TWC. (See
2. Remove the insulator (front). (See
3. Remove the insulator (middle). (See
MSP].)
4. Protect the propeller shaft with rubber padding or similar protective cover to prevent damage.
CAUTION:
Remove the rubber padding or similar protective cover after propeller shaft
EXHAUST SYSTEM REMOVAL/INSTALLATION
EXHAUST SYSTEM REMOVAL/INSTALLATION
EXHAUST SYSTEM REMOVAL/INSTALLATION [13B-
[13B-MSP].)
[13B-MSP].)