Mazda RX-8 Workshop Manual page 1617

Is there continuity?
INSPECT BRAKE FLUID PRESSURE
6 SENSOR
Inspect the brake fluid
pressure sensor.
(See BRAKE FLUID PRESSURE
SENSOR
Is the brake fluid pressure
sensor normal?
VERIFY DTC TROUBLESHOOTING
7
COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the
memory.
(See ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY
CONTROL
Start the engine and drive the
vehicle at 20 km/h {13
mph} or more for 60 s or
more.
Are the same DTCs present?
(See ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY
CONTROL
VERIFY AFTER REPAIR PROCEDURE
8
Are any other DTCs present?
(See ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY
CONTROL
< Previous Next >
Brake light
noise filter
terminal B—
DSC HU/CM
terminal N
INSPECTION.)
(DSC)].)
(DSC)].)
(DSC)].)
© 2010 Mazda North American Operations, U.S.A.
YesGo to the next step.
No Replace the DSC HU/CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION.)
YesRepeat the inspection from Step 1.Replace the DSC HU/CM, then go to
the next step.
If the malfunction recurs, replace the DSC HU/CM, then go to the next
step.
(See DSC HU/CM REMOVAL/INSTALLATION.)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
No DTC troubleshooting completed.
(DSC)].)
Back to Top