Mazda RX-8 Workshop Manual page 1626

Is there continuity?
VERIFY THAT THE SAME DTC IS NOT PRESENT
5
Make sure to reconnect all disconnected connectors.
Clear the DTCs from the memory.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
(DSC)].)
Start the engine and drive the vehicle at 45 km/h {28 mph} or
more.
Are the same DTCs present?
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
(DSC)].)
VERIFY THAT NO OTHER DTCS ARE PRESENT
6
Are any other DTCs output?
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
(DSC)].)
< Previous Next >
RF ABS wheel-speed sensor (–): O
LF ABS wheel-speed sensor (+): F
LF ABS wheel-speed sensor (–): E
RR ABS wheel-speed sensor (+): I
RR ABS wheel-speed sensor (–): L
LR ABS wheel-speed sensor (+): G
LR ABS wheel-speed sensor (–): H
© 2010 Mazda North American Operations, U.S.A.
SENSOR
REMOVAL/INSTALLATION.)
(See REAR ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION.)
YesRepeat the inspection from Step
1.
If the malfunction recurs, replace
the DSC HU/CM, then go to the
next step.
(See DSC HU/CM
REMOVAL/INSTALLATION.)
No Go to the next step.
YesGo to the applicable DTC
inspection.
(See ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY CONTROL
(DSC)].)
No DTC troubleshooting completed.
Back to Top