Mazda RX-8 Workshop Manual page 1567

terminal AA (harness
side) and ground.
Is the voltage B+?
VERIFY VALVE RELAY OPERATION
3
Turn the ignition switch
off.
Connect all disconnected
connectors.
Connect the M-MDS to
the DLC-2.
Turn the ignition switch
to the ON position
(engine off).
Access ABS_POWER
active command modes
using M-MDS.
Does the valve relay
operate?
VERIFY TROUBLESHOOTING
4 COMPLETED
Clear the DTC from the
memory.
(See
DIAGNOSIS
Is the same DTC
present?
(See
DIAGNOSIS
VERIFY AFTER REPAIR PROCEDURE
5
Are any other DTCs
present?
(See
DIAGNOSIS
< Previous Next >
ON-BOARD
[ABS].)
ON-BOARD
[ABS].)
ON-BOARD
[ABS].)
© 2010 Mazda North American Operations, U.S.A.
YesGo to the next step.
No Replace the ABS HU/CM, then go to next step.
(See ABS HU/CM
YesReplace the ABS HU/CM, then go to next step.
(See ABS HU/CM
No Go to the next step.
YesGo to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS
No DTC troubleshooting completed.
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
[ABS].)
Back to Top