Optional Software; Applock (Option); Bluetooth (Option); Java (Option) - LXE MX8 Reference Manual

68

Optional Software

AppLock (Option)

The AppLock program is accessed by the user or the AppLock Administrator at bootup or upon
completion of a warm boot. Set parameters using the Administration option in the Control
Panel. See Chapter 6 AppLock for instruction.

Bluetooth (Option)

Only installed on a Bluetooth equipped MX8. The System Administrator can Discover and Pair
targeted Bluetooth devices for each MX8. The System Administrator can enable / disable
Bluetooth settings and assign a Computer Friendly Name for each MX8. The Bluetooth control
panel can be accessed by tapping Start | Settings | Control Panel | Bluetooth, or by
doubletapping the Bluetooth icon in the taskbar or on the Desktop.

JAVA (Option)

Installed by LXE. Files can be accessed by tapping Start | Programs | JEM-CE. Doubletap the
EVM icon to open the EVM Console. A folder of JAVA examples and Plug-ins is also installed
with the JAVA option. LXE does not support all JAVA applications running on the mobile device.

LXE RFTerm (Option)

Installed by LXE. The application can be accessed by tapping Start | Programs | RFTerm. Please
refer to Terminal Emulation Setup earlier in this guide for RFTerm quick start instruction. Refer to
the RFTerm Reference Guide on the LXE Manuals CD for complete information and instruction.
WAV files added by the user should be stored in System\LXE\RFTerm\Sounds.

Wavelink Avalanche Enabler (Option)

The following features are supported by the Wavelink Avalanche Enabler when used in
conjunction with the Wavelink Avalanche Manager. After configuration, Enabler files are
installed upon initial bootup and after a hard reset. Network parameter configuration is supported
for:
•
IP address: DHCP or static IP
•
RF network SSID
•
DNS hosts (primary, secondary, tertiary)
•
Subnet mask
•
Enabler update
The MX8 has the Avalanche Enabler installation files loaded, but not installed, on the mobile
device when it is shipped from LXE. The installation files are located in the System folder on CE
devices. The installation application must be run manually the first time Avalanche is used. After
the installation application is manually run, a reboot is necessary for the Enabler to begin normal
performance. Following this reboot, the Enabler will, by default, be an auto-launch application.
This behavior can be modified by accessing the Avalanche Update Settings panel through the
Enabler Interface. The designation of the mobile device to the Avalanche CE Manager is
LXE_MX8.
See Wavelink Avalanche Enabler Configuration at the end of this chapter for instruction. See also
Using Wavelink Avalanche on LXE Windows Computers.
If the user is NOT using Wavelink Avalanche to manage their mobile device, the Enabler
should not be installed on the mobile device(s).
MX8 Reference Guide
Installed Software
E-EQ-MX8RG-A