Factory Default Settings - LXE MX8 Reference Manual

Factory Default Settings

Factory Default Settings
If "Send Key Messages ..." is checked any data scan is converted to keystrokes and sent to the
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using "Wedge".
Disable "Enable Internal Scanner Sound" when you want an application, not the scan engine or the
CE operating system, to control scanner audible notifications. Adjust the settings and tap the OK
box to save the changes. The changes take effect immediately.
Disable "Use Illumination LEDs" when the integrated imager does not have illumination LEDs.
E-EQ-MX8RG-A
Factory Default Settings
Main
Port 1
Port 2
Port 3
Send key messages (WEDGE)
Enable Internal Scanner Sound
Use Illumination LEDs
COM1 Port (external serial port)
Baud Rate
Stop Bits
Parity
Data Bits
Barcode
Enable Code ID
Vibration
Good Scan Vibration
Bad Scan Vibration
Figure 4-1 Scanner Control Panels
Internal
Disabled
Disabled
Enabled
Enabled
Enabled
9600
1
None
8
None
Off
Long
145
MX8 Reference Guide