Power Button; Reboot Sequence; Attach The Stylus Clip (Optional); Figure 9 Power Button - LXE MX3-CE User Manual

Hide thumbs Also See for MX3-CE:

Table of Contents

Power Button

Note:

The power button is located above the ESC key on the keypad. When a battery is inserted in the

MX3-CE for the first time press the Power button.

Quickly tapping the Power button places the MX3-CE immediately in Suspend mode. Quickly

tapping the Power button again, or touching the screen, immediately returns the MX3-CE from

Suspend.

Please refer to the section titled "Power Modes" in the MX3-CE Reference Guide for a list of the

kinds of activities (Primary Events) that will return the MX3-CE from Suspend Mode. Dimmed

primary events on the Primary Events screen in the Control Panel are non-functional.

Hold the Power key down until the display goes out (15 seconds), then release the Power button.

When the WinCE desktop is displayed or an application begins, the power up (or reboot)

sequence is complete. If you have previously saved your settings, they will be restored on reboot.

Carefully remove the paper backing from the Stylus Clip sticky. Firmly press the sticky side of the

clip onto the MX3-CE and hold in place for 15 seconds. Thread the tether through the end of the

stylus and tie the ends firmly to the Stylus Clip so that the ends don't interfere with placing the

stylus in the Stylus Clip. Place the stylus in the Stylus Clip when not in use.

MX3-CE User's Guide

Refer to the section titled "Power Modes" in the MX3-CE Reference Guide for

information relating to the power states of the MX3-CE.

Quick Start

E-EQ-MX3CEOGWW-F-ARC

Table of Contents