Wpa/Leap Authentication - LXE MX8 Reference Manual

188

WPA/LEAP Authentication

Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Administrator password and tap OK.
Tap the Profile tab.
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open. Set EAP Type to LEAP. Set Encryption to WPA TKIP.
To use Stored Credentials, tap the Credentials button. No entries are necessary for Sign-On
Credentials as the user will be prompted for the User name and Password when connecting to the
network.
Enter the Username in the Credentials popup text entry box, if desired. Enter the Password, if
desired. Tap OK.
Tap the Commit button to save the new profile configuration.
Perform a warm boot (or Suspend/Resume) to connect using the new profile configuration.
See Also: LEAP w/o WPA earlier in this section to configure the client for LEAP without WPA.
See Also: Sign-on vs. Stored Credentials earlier in this chapter if the username and password are
left blank during setup.
MX8 Reference Guide
Figure 5-19 Configure a Summit Profile with LEAP for WPA TKIP
Figure 5-20 LEAP Credentials
Summit Client Configuration
E-EQ-MX8RG-A