Leap W/O Wpa Authentication - LXE MX8 Reference Manual

184

LEAP w/o WPA Authentication

If the Cisco/CCX certified Access Point (AP) is configured for open authentication, set the Auth
Type client parameter to Open.
If the AP is configured for network EAP only, set the Auth Type client parameter to LEAP.
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Admin Login password and tap OK.
Tap the Profile tab.
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open.
Set EAP Type to LEAP.
Set Encryption to Auto WEP.
To use Stored Credentials, tap the Credentials button.
No entries are necessary for Sign-On Credentials as the user will be prompted for the User name
and Password when connecting to the network.
Enter the Username or Domain \Username in the Credentials popup text entry box, if desired.
Enter the Password, if desired. Tap OK.
Tap the Commit button to save the new profile configuration. Perform a warm boot to connect
using the new profile configuration.
See Also: WPA/LEAP Authentication later in this section to configure the client for WPA LEAP.
MX8 Reference Guide
Figure 5-13 Configure a Summit Profile for LEAP w/o WPA
Figure 5-14 LEAP Credentials Dialog
Summit Client Configuration
E-EQ-MX8RG-A